Lay AERO-ROOF® on top of the wire ceiling frame with the side of aluminum foil facing up.
1. Installation on flat ceiling frame
If the width of the wire ceiling frame is less than the width of AERO-ROOF® cut AERO-ROOF® as shown in the photo and insert AERO-ROOF® to fit the wire ceiling frame.
Seal the joint on the foil side with Alutape aluminum tape, and seal the joint on the rubber side with Aerotape insulation foam tape.
Follow the previous steps until the whole area is finished, then make sure the installation is completed in good condition.
2. Installation of the insulation above the purlin prior to installation of roof (Metal Strip)
Place metal strip in accordance to the width of AERO-ROOF® (Standard of 1.2 meters), then screw to the metal strip firmly with the purlin.
Place AERO-ROOF® along to the length of the roof by put the foiled-side down in accordance to the metal strip and screw tight.
Put AERO-ROOF® closely together, and then use Roof-Tape to attach between the sheets. The end part of the insulation can be neatly folded to the roof.
• Install the metal sheet in accordance to metal sheet installation manual, both Bolt and Boltless. Using appropriate length of screw (The screw should be a half of size longer in order to support the thickness of the insulation)
3. Installation of the insulation above the purlin prior to installation of roof (Metal Strip)
Place metal strip in accordance to the width of AERO-ROOF® (Standard of 1.2 meters), then screw to the metal strip firmly with the purlin.
Place AERO-ROOF® along to the length of the roof by put the foiled-side down in accordance to the metal strip and screw tight.
Put AERO-ROOF® closely together, and then use Roof-Tape to attach between the sheets. The end part of the insulation can be neatly folded to the roof.
• Install the metal sheet in accordance to metal sheet installation manual, both Bolt and Boltless. Using appropriate length of screw (The screw should be a half of size longer in order to support the thickness of the insulation)